After you mastered flying the Invader airplane, head over to the Dreamer airplane and try taking-off from the ground. Please follow this step by step tutorial which will show you how to assemble the landing gear, rear skid and Dreamer airplane, proper assembly is essential for achieving takeoff and landing capabilities.
1- Hold the rear skid connector under the main body carbon rod and align.
2 - Carefully rotate clockwise the connector until the crossbar is perpendicular to the main body rod and until you feel a click locking action. You must hold the main body rod with your other hand and NOT put side pressure on the main body while locking, too much side pressure on the rod could damage the main carbon rod.
3 - After locking the rear skid onto the main carbon body slide it to the rear.4 - Locate the landing gear U shape between the clips and the rear tiny fin.5 - Slide the landing gear all the way to the front of the clips until it is in place.6 - Fold the P1 Dreamer template which is designed for takeoff and landing, the Invader model is not designed for ground takeoff and may not work.7 - Slide the airplane into the clip all the way, if the wheel frame rotates nudge it into place, when sliding the airplane under the clips apply upward pressure.8 - Locate the rear skid tail in the V groove on the rear side of the airplane, slide it slightly forward so it sits over the wing, this is required to hold the wing angle and eliminate rotation of the rear skid during hard landings. Apply scotch tape in the marked location. Verify that the main carbon rod is located flat on the wing and exactly in the center of the airplane.9 - Cut both Elevators using scissors on the black marked lines and raise slightly. Cut also the rear rudder on the Keel and bend slightly to the right.10 - This is how your assembled Dreamer airplane should look like ready for take of from the ground.
Please watch the tutorial video explaining how to trim and take off from the ground - COMING SOON.